Motion & M2M coverage

Matrix Games Forums

Forums Register Login Photo Gallery Member List Search Calendars FAQ

My Profile Inbox Address Book My Subscription My Forums Log Out

Motion & M2M coverage

View related threads: (in this forum | in all forums)

Logged in as: Guest

Users viewing this topic: none

Printable Version

All Forums >> [Current Games From Matrix.] >> [Sports] >> Maximum-Football 2.0 >> Play Development System (PDS) >> Motion & M2M coverage

Page: [1]

Message

<< Older Topic Newer Topic >>

Motion & M2M coverage - 2/3/2008 7:42:09 PM

Yngvai

Posts: 82
Joined: 1/5/2008
Status: offline

Something I've noticed about M2M coverage when a guy goes into motion. A receiver goes into motion, going laterally, and the DB follows him. When the computer is snapping the ball, the computer often snaps the ball soon after the motion begins. After the snap, if the receiver continues to move laterally, the DB will studder, move towards him, studder again, then continue following him. The receiver gets pretty open when this happens because the DB falls way behind him. The DB does this regardless of whether he's in under, over, or deep coverage.

Is there any way to prevent this from happening?

Post #: 1

RE: Motion & M2M coverage - 2/3/2008 9:21:07 PM

Marauders

Posts: 4428
Joined: 3/17/2005
From: Minnesota
Status: offline

Another good observation, Yngvai.

I had brought something similar up in the private forum.

David was taking a look at it to make a small change in coverage that may clean this up a bit.

I can't go into it more than that, as we are still testing.

(in reply to Yngvai)

Post #: 2

RE: Motion & M2M coverage - 3/27/2008 6:24:54 AM

Yngvai

Posts: 82
Joined: 1/5/2008
Status: offline

I'm not sure if this was intended to be fixed or changed, but I did see that this still happens in version 2.2.

(in reply to Marauders)

Post #: 3