Slitherine

quote:

ORIGINAL: Qwixt

Not sure if this was brought up, in the example where one hex is advanced to 5, and the others drop the median of 2, what happens if you bombard the hex at turn 5? It's kind of like going backward in time. Does it change the combat results shown? What about adding additional units to the fight, does that change the results for the original units?

quote:

ORIGINAL: Curtis Lemay

quote:

ORIGINAL: Qwixt

Not sure if this was brought up, in the example where one hex is advanced to 5, and the others drop the median of 2, what happens if you bombard the hex at turn 5? It's kind of like going backward in time. Does it change the combat results shown? What about adding additional units to the fight, does that change the results for the original units?

From the article:

Combat effects of Battlefield Time Stamps: Combats planned for a hex with a Battlefield Time Stamp will start on a combat round as if the player-turn is the same as the hex’s time stamp. All units that participate in a combat that results in a Battlefield Time Stamp have their time stamps increased to the resulting time stamp of the battlefield.

So, if further combats are set up for that hex, prior to round 5, all participants have their time stamps increased to 5.

After all combats are resolved and the combat phase has been advanced, all Battlefield Time Stamps on the map that are either less than or equal to the new time stamp of the player-turn are erased.

So, when the round reaches round 5, the BTS in that hex is removed (assuming there hasn't been a later BTS incurred there).

quote:

ORIGINAL: Curtis Lemay

quote:

ORIGINAL: X.ray

But what I said above was not really a "WEGO" system as the other side did not "go".

So, all the problems of WEGO but none of the benefits?? The two sides are not moving simultaneously, but the units are moving mindlessly. Sounds like the worst of both worlds.

quote:

ORIGINAL: X.ray

Well, such problem (time travel) exists as long as a unit can perform multiple actions in a turn, i.e. move, attack, move again, attack again etc. And it's not just TOAW that has it. Other turn based games have the same issue too. I believe the purpose of having battle rounds in a turn is to address that issue, i.e. to "dial" every unit's clock to the same moment after each battle. However this action of "dialing" only applies after battles but not after movement, therefore time travel caused by movement still exists. The BTS system only addresses part of it.
I was hoping there could be a system that could address the entire movement part as well. I don't think it would make it a half "WEGO", as it doesn't change the way the original game works. The only thing it does is to make sure all units, including those who participated a battle, and those who didn't, will have their clocks synced at all times. I'm sure someone would come up with a perfect solution one day
I knew WEGO or RTS would address all these issues but I just don't feel they are PBEM friendly, nor they are very practical at the operational / campaign level (unless you have many participants playing simultaneously as the military does in their professional simulations).

quote:

ORIGINAL: Curtis Lemay

I can only think of a couple of time-machine issues with movement:

1. Recon turning up previously unknown enemy units and allowing friendly reaction to this new info by units with lower time stamps.

The problem is that plotted movement (even full-blown WEGO) has it worse: No units - even at the same or later time stamps - can react to such info. Everybody has to keep on as plotted, regardless. (This mindlessness is my main objection to WEGO).

quote:

ORIGINAL: Curtis Lemay

2. Potential stacking/density effects that could occur dynamically are avoided.

Here the problem is that those are phony stacking/density effects anyway, and effecting them would actually be wrong. Those effects only really should apply at the end of the unit's movement - when units in front are stopped and the unit has to exit the road to enter the hex, or take up a slot in the front lines, etc. While everyone is still moving, those issues mostly don't apply - certainly they don't apply to the extent that they do at the destination.

So, unless there is some other effect I'm missing, I still don't see the point of plotting movement just to make movement take place simultaneously.

quote:

ORIGINAL: X.ray

Why can't it be made that units can react to such info? For example, if a unit was moving through a path but stopped because a retreating enemy unit is now on its way due to a recent battle, then the unit should be able to choose to fight the enemy unit, or stop movement and defend current position, or retreat.

quote:

How about the scenario that Lobster mentioned, i.e. the active player can use a moving unit to block the retreating path of enemy units even though by the time the battle happens the moving unit shouldn't have arrived (say the battle ends in round 2, but the moving unit needs to use 100% of its MP to get to the position). It seems to me only by making movement simultaneous with battles this could be addressed. Not sure if I missed anything.

quote:

There are also potential effects on ZOC as odoakr mentioned,

quote:

and maybe supply as well (though I'm not sure about this point).

quote:

ORIGINAL: juntoalmar

I understand how TOAW simulates the time spend in the turn, so that combats involving units that have spent some of their movement are affected.

Let's say unit A and B are attacking an adjacent hex, with the help of unit C that is moving 80% of its movement factor before joining the combat. The timestamp systems calculates the delay caused by a "late" unit joining the combat and the combat will end on impulse 8, instead of 1.

But isn't it some kind of artificial/confusing solution? It means that while moving the units in the map, some of them are in different times in the turn. Some units in the map represent they are in impulse 3 while others in 7.

I mean, wouldn't be easier if you just move & attack with all your units in 10 independent impulses? In the example it would be moving unit C during 8 impulses while A & B wait during these 8 impulses and then attacking all together. I know it may mean issuing more orders, but at any time you can see in the map exactly where all the units are at that precise time/impulse.

Seems more intuitive to me.

quote:

ORIGINAL: Joe 98

What if a group of sibling units begin their turn at the front line and all wish to attack three enemy hexes and achieve break through. They can pour through that centre hex.

Meanwhile another sibling unit starts at the edge of the map and uses all its movement points to stack with the other units. I know the game rules and I will not use it in the combat. However it has entered a hex that has been time stamped. What affect does the unit have on the combat and the subsequent exploitation by the other sibling units?

quote:

ORIGINAL: Curtis Lemay


There remains the risk of early turn ending after each combat phase. That's only intended to impact combat plans. It shouldn't impact the movement of units that aren't in combat (reinforcements moving in the rear areas or other units just maneuvering). And you still have the risk of combats that, while starting on time, last multiple rounds. Do they go into limbo?

quote:

ORIGINAL: juntoalmar

I don't see why. If you can deliver orders for the 10 impulses, you can move units and/or initiate/continue a combat in any impulse.

What it seems a bit confusing to me is the paradigm used. Let's say a turn represents a full day with the impulses about 2,4 hours. If unit A move 70% of its movement allowance and B is ready to attack, they both are represented at the same time in the map but at different times during the day turn (it's 7pm for A, and 00:00 for B) so they have to adjust (delay B) so that they attack together. If you deliver orders independently you could do something like this without the stress of bothering the timestamp of each unit. Every impulse you see exactly where all the units are at that impulse/moment of the day.

Impulse 1: A (moving) B (resting)
Impulse 2: A (moving) B (resting)
Impulse 3: A (moving) B (resting)
Impulse 4: A (moving) B (resting)
Impulse 5: A (moving) B (attacking alone)
Impulse 6: A (moving) B (attacking alone)
Impulse 7: A (moving) B (attacking alone)
Impulse 8: A (moving) B (attacking alone)
Impulse 9: A + B (attacking together)
Impulse 10: A +B (attacking together)

right now is something like

A (moving) B (resting)
A+B attack together: be careful because A has a timestamp representing that has already used most of the time in its impulse, thus attacking together will make the whole turn moves up to 9th impulse.

I guess to properly represent the same scenario you should:

- Move A
- Attack only with B
- Keep on attacking with B and checking by yourself when it's the time to add A to the combat so you don't miss some impulses.

Is that correct?

Is just different paradigms to represent the same time passing by during a turn...

quote:

ORIGINAL: Curtis Lemay

At the end of each combat phase there is a check against the attacking force's Force Proficiency. If that check fails, the player-turn ends, regardless of how much of the turn has been expended.

quote:

ORIGINAL: juntoalmar

quote:

ORIGINAL: Curtis Lemay

At the end of each combat phase there is a check against the attacking force's Force Proficiency. If that check fails, the player-turn ends, regardless of how much of the turn has been expended.

I see, thanks. I kind of understand the game dynamics (I think) but I still don't understand what it is supposed to simulate that behaviour in real life combat. I mean, one silly attack won't stop the whole front.

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

quote:

ORIGINAL: Lobster

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

To the casual observer it would seem you have not played TOAW.

quote:

ORIGINAL: Curtis Lemay

quote:

ORIGINAL: X.ray

Why can't it be made that units can react to such info? For example, if a unit was moving through a path but stopped because a retreating enemy unit is now on its way due to a recent battle, then the unit should be able to choose to fight the enemy unit, or stop movement and defend current position, or retreat.

It probably can. But look at the tiny list of options you made: That's only a micro-subset of what the PO has at its disposal. And think what a crummy player the PO is! No human gets to intervene in the units' movements. (Which is my other issue with WEGO: brainless wargaming - kind of like letting the PO control all your formations (which you can now do, by the way)).

quote:

ORIGINAL: Curtis Lemay

quote:

ORIGINAL: X.ray
How about the scenario that Lobster mentioned, i.e. the active player can use a moving unit to block the retreating path of enemy units even though by the time the battle happens the moving unit shouldn't have arrived (say the battle ends in round 2, but the moving unit needs to use 100% of its MP to get to the position). It seems to me only by making movement simultaneous with battles this could be addressed. Not sure if I missed anything.

That's not even an issue till combat. And then it is addressed by the BTS system.

quote:

ORIGINAL: Curtis Lemay

If it takes up a position to block a defender's retreat, and the unit is destroyed, instead, because of it, then it will increase the resulting BTS.

quote:

ORIGINAL: juntoalmar

quote:

ORIGINAL: Lobster

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

To the casual observer it would seem you have not played TOAW.

... but who wants to understand it in order to consider to play.

quote:

ORIGINAL: X.ray

Thanks Bob for your patience. And forgive me being a dumbass - I still couldn't understand, why "No human gets to intervene in the units' movements"? Is it because there are some considerations that make it impractical, or because the game designer wouldn't design it that way? In my simple mind the human can and should get to intervene in the units' movements when certain things happen, e.g. unexpected enemy enounter, original attack plan gets cancelled because enemy is knocked out by other units, etc. And it should not be difficult to achieve - the player turn just needs to automatically pause on the round when such things happen, as if it now pauses on the round when the median battle completes. So simply speaking the player turn will have more stopping conditions than just finishing combats.

quote:

So even though the blocking unit does not participate in the combat, if its existance played a role in the final combat result, the clock would run as if it has participated in the combat, and the combat would actually start in the round after this blocking unit arrive, instead of before (when all actual attacking units arrive), correct?

quote:

Now here's the question:
If the target unit is not destroyed - i.e. the blocking unit is too weak to block the way - would the BTS be increased the same way as the case above? You didn't mention, but I would assume yes, given the blocking unit would have effectively participated in the combat in this case as well (though not successful).

quote:

Then there's the thrid possible outcome: the target unit is destroyed right away under the attack (it didn't even get the chance of trying to retreat). In this case, the blocking unit would not have to participate in the combat, then does the BTS get to increase as a result of the presence of the blocking units?

quote:

If not, that means the attacking units would have 100% correctly predicted the result of the combat before they decide when to launch the attack, i.e. they need to know the enemy had no chance in order to start the attack in say, round 2, instead of round 8 when the blocking unit arrives. If they predicted it wrongly (i.e. enemy not vaporizing but instead retreating), then the enemy would have fled in round 3, way before the blocking unit arrives in round 8, thus causing the time travel issue that Lobster mentioned.

quote:

ORIGINAL: Curtis Lemay

It probably can. But look at the tiny list of options you made: That's only a micro-subset of what the PO has at its disposal. And think what a crummy player the PO is! No human gets to intervene in the units' movements. (Which is my other issue with WEGO: brainless wargaming - kind of like letting the PO control all your formations (which you can now do, by the way)).

quote:

ORIGINAL: juntoalmar

quote:

ORIGINAL: Lobster

quote:

ORIGINAL: Joe 98

Basically across the map I have planned 3 turns in advance and I wish to make 3 major attacks spread across the map.

Your comment about a too complex plan or extra rounds frightens me!

To the casual observer it would seem you have not played TOAW.

... but who wants to understand it in order to consider to play.

quote:

ORIGINAL: Joe 98

Its not an AAR that's required.

Rather for TAOW 111, I need a "Take mouse in hand, click here and click there" etc.

For example, when looking at any screen, how can I tell who's turn it is?

.