mavfin
Posts: 274
Joined: 6/22/2010
Status: offline
|
Group Strike Mission issue.
Easiest to see in Tacview. Found I couldn't modify the group height...looked in unit view, one of the group was at 36000 feet, the other at 6000 feet. (closer to 1000 because of ground height.)
Been seeing this in tacview all evening.
This one's been a real ****show this time. Won't attack, taking missile fire, out of antiradar missiles, but I split them into singles and they climbed all to 36000 feet, rather than going down for CBU runs on target. Took like 6 circles for some of them to drop bomblets even on a *manual* attack.
Definitely the next thing to address. I suspect it's the plotted course logic is messing up something, especially for groups.
Going to try a different tack with the SAM sites. See if a SEAD patrol will do the job.
Seems like strike missions against any kind of SAM opposition is WAY too dicey at the moment, because about half the time (hmm, perhaps there's still trash in the data location after the 1st scen, that isn't getting cleared?) it just goes off the rails. Anyway, here's the pic. I hope they can do something with it.
I think that's enough testing for today for me. Disgusted.
 Attachment (1)
|
Printable Version
Same Scenario again, group altitude issues + - 
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread