GM an association (Full Version)

All Forums >> [Current Games From Matrix.] >> [Sports] >> PureSim Baseball



Message

joeblack1862 -> GM an association (10/6/2006 12:46:59 AM)

I realise I might be going over old ground here, but as a newbie, maybe someone can answer another question for me.

Is it possible for more than one team to be controlled by a human player in solo mode?



XCom -> RE: GM an association (10/6/2006 4:10:24 AM)

If you select multiplayer when creating your association you can then assign more than one team to be human controlled.

quote:

ORIGINAL: Joe Black

I realise I might be going over old ground here, but as a newbie, maybe someone can answer another question for me.

Is it possible for more than one team to be controlled by a human player in solo mode?




Amaroq -> RE: GM an association (10/6/2006 10:05:12 PM)

"Multiplayer" does not equal "Multi-computer".



joeblack1862 -> RE: GM an association (10/6/2006 10:32:48 PM)


quote:

ORIGINAL: Amaroq

"Multiplayer" does not equal "Multi-computer".


I only have one PC so I understood by default [:)].

Maybe you could give me some advice.

I tried creating a multiplayer association about 3 times. Every time it finished the initial draft it crashed with unexpected error 3265 (item not found in this collection). Set up as 1.38. Re-installed and it did the same thing everytime I chose multi player. Solo works fine and will create exactly the same association without a hitch.

Any experience of this problem?



XCom -> RE: GM an association (10/7/2006 3:38:43 AM)

quote:

ORIGINAL: Joe Black

I tried creating a multiplayer association about 3 times. Every time it finished the initial draft it crashed with unexpected error 3265 (item not found in this collection). Set up as 1.38. Re-installed and it did the same thing everytime I chose multi player. Solo works fine and will create exactly the same association without a hitch.

Any experience of this problem?



Yes, I think this is a problem that was introduced in one of the recent patches and Shaun is currently looking into it. I ran into a similar problem using 1.37 and when I re-installed an earlier patch (1.31) then I had no problem creating a multiplayer league.



joeblack1862 -> RE: GM an association (10/7/2006 11:54:32 AM)

Thanks once again XCom, your replies are much appreciated.

As the problem is in hand I'll wait the fix. Do you know where I can get the older patches from? Went theough the forum, tried some of the links and they failed.

At the moment I can only go back to 1.20, the public patch release.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.828125