Mine Decay Question (Full Version)

All Forums >> [Current Games From Matrix.] >> [World War II] >> War In The Pacific - Struggle Against Japan 1941 - 1945



Message

Chad Harrison -> Mine Decay Question (3/1/2007 4:57:50 PM)

Hey all

Just looking for some clarification on mine decay. The manual says that mines decay 50% in deep water, 5% in shallow water, and 1% in friendly bases w/ a port size of atleast 1.

Does the decay rate have a minimum amount that needs to decay each day? ie. the least a minefield can decay each day is 1 mine, no fractions or parts. Because, at 1% decay, it takes 69 days to loose half your mines. But thats only if you can loose a fraction of mines each day.

Also, how fast do mines decay in enemy ports? Its not 1%, so is it either 5 or 50 depending on how deep the water is around the port?

Thanks

Chad



USSAmerica -> RE: Mine Decay Question (3/1/2007 5:05:02 PM)

Chad, you're correct on your second point.  Either 5% or 50% for your mines in enemy ports.  (Are there ports in deep water hexes?)

The first question about fractions of a mine decaying needs input from one of the crack WitP research staff around here.  [:D]  I guarantee someone has "tested' this. 



Mike Solli -> RE: Mine Decay Question (3/1/2007 5:06:34 PM)

My guess is that at least one mine decays each turn.  I've seen 1 mine minefields disappear.



HansenII -> RE: Mine Decay Question (3/2/2007 2:49:01 PM)

Hi!

How do I see how big a minefield is?
How do I mine own ports?

Regards



Terminus -> RE: Mine Decay Question (3/2/2007 2:53:01 PM)

Number of friendly mines are shown in the Port Data screen. You mine your own ports by creating a Mine Warfare TF with one or more mine-carrying ships/subs in, setting their destination to the port in question, and making sure they have "Lay Mines" turned on (it's right under the picture on the Task Force display screen).



USSAmerica -> RE: Mine Decay Question (3/2/2007 2:57:37 PM)

You can't see the size of your minefields at enemy bases, nor the size of enemy minefields anywhere.  To see the size of friendly minefields at friendly bases, open the base display and look at the middle of the base info screen, near the top.

To mine your bases, load your ML, set one of your bases as destination, set Retirement Allowed, then be sure to click the Do Not Lay Mines setting to change it to Lay Mines. 



USSAmerica -> RE: Mine Decay Question (3/2/2007 2:58:35 PM)

Why do I even try when Terminus is online...[:D]



Terminus -> RE: Mine Decay Question (3/2/2007 3:03:39 PM)

Hey, don't blame me, my post had been up for almost five minutes...[:'(]



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
2.046875