OOB not fully deployed (Full Version)

All Forums >> [Current Games From Matrix.] >> [World War II] >> Norm Koger's The Operational Art Of War III >> Scenario Design



Message

Bkim -> OOB not fully deployed (1/14/2009 8:52:00 PM)

I have completed the Forces Editing and am attempting to Deploy the units, however I am receiving an error msg at this point. "The OOB is not fully defined".
I viewed the OOB and see that there are two units (copied- unit ID with + after) listed as unassigned. I can't find the units anywhere in the "Forces" development screens. Short of deleting the entire "Forces" setup is there anything else I can do?

Bkim



Telumar -> RE: OOB not fully deployed (1/14/2009 9:15:55 PM)

quote:

the "Forces" development screens


This confuses me a bit. What do you mean by that?

Open the menu edit->forces (this is where you should have seen the unassigned units) You must assign them to a formation respectively create a new one for those two units. Just right click on the "unassigned" button and select "New formaton". Does that help?



Bkim -> RE: OOB not fully deployed (1/15/2009 1:36:09 PM)

The units do not show in the Force Editor. All other units have been assigned. I only knew about them because they show when I "view the OOB". They show up as the last two units. [&:]



ColinWright -> RE: OOB not fully deployed (1/15/2009 6:12:29 PM)


quote:

ORIGINAL: Bkim

The units do not show in the Force Editor. All other units have been assigned. I only knew about them because they show when I "view the OOB". They show up as the last two units. [&:]


If this was happening to me, and if the situation was as described, then I would go to the force editor, go to the end of the list, go to the next unit, and try deleting it. Then repeat.

If that didn't work, then I'd go back, go to these units, make them something, assign them to a formation, and then see where I was. Assuming that worked, then I'd go back and delete the units.



Telumar -> RE: OOB not fully deployed (1/15/2009 8:50:23 PM)

Or export the units with F4, delete the two units in the oob file and re-import the OOB via F5.



Bkim -> RE: OOB not fully deployed (3/10/2009 12:49:12 AM)

The offending units (4 Pz Bde+- twice) only show in the OOB screen (menu-view-oob), but not in the Force Editor.

I attempted the F4 and it exported the OOB at the platoon level (Inf, Tanks, etc).

Any other suggestions?

thanks

bkim



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
1.355469