Aussie units won't load from Sydney (Full Version)

All Forums >> [New Releases from Matrix Games] >> War in the Pacific: Admiral's Edition



Message

mephistofileez -> Aussie units won't load from Sydney (11/3/2009 9:39:35 PM)

Hey guys,

I decided to finally break down and "ask for directions". I've played WitP years ago, and just now purchased the AE version. I thought I finally figured out how to load troops and move them about, but for some reason I can't get troops to load from Sydney to reinforce PM. When I call up the load troops screen, I only get the unit attached to the SW Pacific. PM is under Aussie command, as are all the troops in Sydney, the port is big enough, and the troops are all strat and ready to go...any ideas would be greatly appreciated.



Q-Ball -> RE: Aussie units won't load from Sydney (11/3/2009 9:46:22 PM)

Australia Command (R) units cannot ever load on a ship. That's what the (R) means. You have to pay PPs if you want to move them. Same as in WITP, only WITP didn't have the handy (R) to remind you.



Jonathan Pollard -> RE: Aussie units won't load from Sydney (11/3/2009 9:46:50 PM)

You'll need to transport them by air. The troops are not allowed to board transports because once on board there's nothing in the program to prevent you from unloading them at an illegal base.



mephistofileez -> RE: Aussie units won't load from Sydney (11/3/2009 11:05:02 PM)

Thanks for the fast responses guys..much appreciated!



Chickenboy -> RE: Aussie units won't load from Sydney (11/4/2009 12:51:37 AM)

Let's face it-would you want to load up in a nice place like Sydney to go to some malarial fen to face a fanatical opponent and maybe get sunk on the way? I mean, I'd find some reason to not load too![:D]



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.7030029