Southwest Pacific Command HQ Can't Be Transferred (Full Version)

All Forums >> [New Releases from Matrix Games] >> War in the Pacific: Admiral's Edition >> The War Room

Message

---

augustinus -> Southwest Pacific Command HQ Can't Be Transferred (2/12/2011 3:22:42 PM) I am nonplussed by this situation. In the Guadalcanal scenario (playing Allies in a PBEM game) I wanted to strategically move MacArthur to PM. After the packing delay my Transport TF could not load him. So, I returned him to combat mode and planned to send him via amphibious TF. That didn't work, either. So, I've got him marching to Townsville. If you note in the screen shot of SWPAC HQ, you can see that it is not static and has a load value. So, what am I doing wrong, again? [&:]

---

Ambassador -> RE: Southwest Pacific Command HQ Can't Be Transferred (2/12/2011 3:36:45 PM) SWHQ is "restricted" in this scenario.  It means it can't be transported by sea or air, or change its higher HQ. You can see that as the HQ line is full white, non-clickable, opposed to a yellow, clickable line in other units. Hmmm, it was much clearer in my mind than written down...[8|]

---

augustinus -> RE: Southwest Pacific Command HQ Can't Be Transferred (2/12/2011 3:54:15 PM) Thanks, Ambassador, for pointing out the obvious to me, which I neglected to note. I was focused on the static thing. Well, I'll keep him marching to Townsville, anyway, he needs the exercise.

---

Ambassador -> RE: Southwest Pacific Command HQ Can't Be Transferred (2/12/2011 4:15:14 PM) You're welcome.  Have a nice game and a lot of fun.

---

Lifer -> RE: Southwest Pacific Command HQ Can't Be Transferred (2/12/2011 7:17:27 PM) You could transfer PM base to Southwest Pac and Air Trans the Hq to PM. I'm pretty sure you can, anyway. Greg

---

Page: [1]

Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI

0.796875