Units Selection (Full Version)

All Forums >> [Current Games From Matrix.] >> [World War II] >> John Tiller's Campaign Series >> John Tiller’s Campaign Series Support



Message

sobibor -> Units Selection (6/4/2012 12:20:41 PM)

How can i select some especific units inside an hex (not all the units inside, only some)? i remember on original Talonsoft I was able to do that but now i can't...



junk2drive -> RE: Units Selection (6/4/2012 1:39:24 PM)

Click the hex with units in it. Press the U key to turn on the side bar that shows the units in the hex. Click the units in the side bar and see that their title highlights. You can also double click the hex to select all the units then click the side bar to deselect as needed.



sobibor -> RE: Units Selection (6/4/2012 3:04:10 PM)

oh, the "U" key; thank you very much



Warhorse -> RE: Units Selection (6/5/2012 12:49:53 AM)

I usually, if in 2D mode, click the hex, then when the infobox is up, keep right-clicking through all the units until who I want. you can highlight thn any one of them for a place-setter to tell where you are. Hope this helps as well!



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.578125