Sticky Range and Bearing (Full Version)

All Forums >> [New Releases from Matrix Games] >> Command: Modern Operations series >> Tech Support

Message

---

dongonzo -> Sticky Range and Bearing (10/24/2013 5:36:16 PM) Sorry if this has been covered before, but is there a way to sticky a range and bearing on the map? I could swear I've seen it done. -DonGonzo

---

Der Zeitgeist -> RE: Sticky Range and Bearing (10/24/2013 5:38:47 PM) Ctrl-D, then klick on the map and move the cursor to see range and bearing.[:)]

---

dongonzo -> RE: Sticky Range and Bearing (10/24/2013 5:44:02 PM) Yes, but is there a way to paste it on the map as you would a reference point?

---

ExMachina -> RE: Sticky Range and Bearing (10/24/2013 5:48:33 PM) Reference points can be designated as being positioned relative to specified units...(is that what you're asking?)

---

dongonzo -> RE: Sticky Range and Bearing (10/24/2013 5:57:06 PM) No, that part I also got... the range and bearing tool [ctrl-d]: can that be stuck on the map as you would a reference point so that when I'm done using the range and bearing tool, the range and bearing I measured with it is left displayed on the map for reference? Once I'm done using the R&B tool, hit esc or what-have-you, remaining upon the map is the white line with the information of xxx nm - xxx deg displayed. The way I'm using it now, that information goes poof as soon as I'm done using the tool and/or click elsewhere on the map.

---

ExMachina -> RE: Sticky Range and Bearing (10/24/2013 6:10:49 PM) What we're suggesting is to use the Control-D option, esc out of that tool, then (without moving cursor), drop a ref point (Ctrl key, insert RP, and then Enter).

---

dongonzo -> RE: Sticky Range and Bearing (10/24/2013 7:06:46 PM) I see, thanks.

---

Page: [1]

Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI

0.5942383