|
Resisti -> (3/7/2003 3:06:38 PM)
|
Not sure about this procedure, but it worth a try:
rename the three save files into “scenxxx” (where xxx stands for an open slot in scenario list), maintaining the same files’ extensions, naturally.
Then place them in the scenario folder, open the editor and load this scenario.
Check if everything’s ok with the map. At this point you’ll probably have the units already deployed on map, so you’ll have so remove them all, then you can save the map. It should do the trick.
Naturally any destroyed vehicle, smoke, craters, etc. will be retained on the map.
In order to have a “clean” map, this procedure should be applied immediately, before the purchasing phase.
Hope it helps.
|
|
|
|
