Railroad Damage display (Full Version)

All Forums >> [New Releases from Matrix Games] >> Gary Grigsby's War in the East Series



Message

sth1119 -> Railroad Damage display (10/16/2015 4:09:46 PM)

I have blown the dust off my WiTE; have not played in a long while. I updated to latest patch and added the MapMod update for the map and symbols.

near the end of my first turn I was bringing some rail units up to begin repairs. I clicked the railroad damage button and found it does not show damage icons on map. If i mouse over a hex i see damage 100 but no icon.

Just wondering if anyone else has seen this. Could it be the mapmod?

I did some quick searches and found no mention, excuse me if this is an old topic.



sth1119 -> RE: Railroad Damage display (10/16/2015 4:15:58 PM)


quote:

ORIGINAL: sth0009

I have blown the dust off my WiTE; have not played in a long while. I updated to latest patch and added the MapMod update for the map and symbols.

near the end of my first turn I was bringing some rail units up to begin repairs. I clicked the railroad damage button and found it does not show damage icons on map. If i mouse over a hex i see damage 100 but no icon.

Just wondering if anyone else has seen this. Could it be the mapmod?

I did some quick searches and found no mention, excuse me if this is an old topic.


PS - I am assuming the damage is shown on the map the same it is shown on WiTW.



gingerbread -> RE: Railroad Damage display (10/16/2015 5:10:53 PM)

There is an old feature that you cannot have a hex selected when you enter rail damage mode, just press esc before. Also, don't have any other map feature enabled, only rail damage.



sth1119 -> RE: Railroad Damage display (10/19/2015 10:34:47 AM)

you are dead on, gingerbread. I had the rail unit selected.

I think i should dust off the manual too! thanks for the quick response.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
1.375