Reset Scenario to Starting Condition? (Full Version)

All Forums >> [New Releases from Matrix Games] >> Command: Modern Operations series >> Mods and Scenarios



Message

gpotter511 -> Reset Scenario to Starting Condition? (2/18/2018 4:00:07 AM)

All - possibly stupid question, but how does one reset a scenario to its starting condition within the editor?

I know have to set the scenario *time* to the beginning, but missions that activated and sensors that were detected while I tested game speed and various aspects are now all revealed, etc. How would one set the scenario so that they continue editing from its original, "undiscovered" state?

Thanks!



Rory Noonan -> RE: Reset Scenario to Starting Condition? (2/18/2018 8:18:02 AM)

My workflow for scenario design is to save a seperate file at certain points, including when I’m about to run the scenario and test. I’ve been caught out too many times with accidentally clicking ‘save’ instead of ‘load’ when trying to revert (and losing all my work or creating more work deleting and resetting stuff).

In short; easiest way is to reload a ‘fresh’ save... but on the off chance you don’t have one, you’ll have to do it all manually. PgDn drops contacts, but the rest is probably going to be lots of RTBing aircraft, moving ships and the like.

Sorry there’s not an easier way.



gpotter511 -> RE: Reset Scenario to Starting Condition? (2/18/2018 5:43:19 PM)

Not at all! Very helpful. Pretty easy to do with where I stand. Thank you!



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.609375