|
LiquidSky -> RE: Amphibious Landings (12/14/2018 2:53:00 AM)
|
To make (or change) an invasion site you need to :
1) Stack an Amphib HQ, and the units that will be invading together in a port. Make sure the units have the support units you want because if you change it later, it will reduce the prep points.
2) Click on the stack. On the right hand panel, where the units are listed...click on the button below the counter image. In the Huskey scenario it will be labeled the hex cooridinate that it is going to invade.
3) It will as if you want to Set New Amphibious Target. Click Yes.
4) Hexes that are yellow are eligible hexes for invasion. RIGHT CLICK (not left click) the hex you want to invade. It will turn Red for the invasion hex, and the Blue is the sea hex you will be invading from.
Fun Facts: If you reset an invasion for a different hex, it halves the prep points already accumulated. EXCEPTION: First turn of any invasion scenarios. The points don't halve.
If you change the unit somehow..like add a support unit. It will reduce the prep points (but not halve...I think it reduces by 10)
You can only paradrop a maximum of 8 hexes from an insupply allied hex. EXCEPTION: You can paradrop adjacent to an invasion hex at the same moment of invading.
To launch an invasion, on the land phase...click the amphibious transport mode button (4th button over). Click on the stack....then hit the invade button next on the amphib.
To paradrop..click the air transport button next to the amphibous button...find the paratrooper and click Drop. It will immediatly drop if within 8 hexes..otherwise it will wait until the invasion and drop then.
|
|
|
|
