I cant unload in harbor (Full Version)

All Forums >> [New Releases from Matrix Games] >> Gary Grigsby's War in the West



Message

fritzfarlig -> I cant unload in harbor (4/24/2020 4:06:51 PM)

help try alot but I cant unload my US army hq, no capacity


[image]local://upfiles/53382/A496ADE17A604D8C92178BEDB2092560.jpg[/image]



loki100 -> RE: I cant unload in harbor (4/24/2020 4:26:53 PM)

at a rough guess its those 102 support units, each has a load and in combination its all far too much for the port capacity, I think you need to take the HQ back to the UK and assign some of the SUs up the chain. Send the HQ over and then re-attach the SUs.



jecunningham -> RE: I cant unload in harbor (4/24/2020 6:24:16 PM)

Your Transportation Cost, 83,818, is larger than the Port Capacity, you see that inside the anchor symbol above the Port in F3 mode. It is definitely the assigned SUs. As you Assign them to other HQs you can watch your Transport Cost go down until it is below the capacity of the port you're landing at, then you can land.




fritzfarlig -> RE: I cant unload in harbor (4/24/2020 7:05:41 PM)

argh ok I notice the huge transport cost 83818 the number on port is 68 this is 68000 ?



fritzfarlig -> RE: I cant unload in harbor (4/24/2020 7:06:21 PM)

[:)][:)][:)]



jecunningham -> RE: I cant unload in harbor (4/24/2020 8:19:37 PM)

Yes, 68 in the port symbol = 68,000 port capacity.



cfulbright -> RE: I cant unload in harbor (4/24/2020 8:40:09 PM)

Fritzfarlig,

Because this is likely due to user inexperience, I recommend you go into the Assigned tab and manually transfer least important units to SHAEF until you get down to a transport size that allows you to unload the HQ in the port. I don't think this is "gamey" or a cheat given you didn't realize the problem.

Cary



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
2.890625