Mysterious Replacements Requested (Full Version)

All Forums >> [New Releases from Matrix Games] >> Shadow Empire



Message

arvcran2 -> Mysterious Replacements Requested (7/20/2021 6:30:13 AM)

Every turn I see reports on failed replacement troops - is this Militia units?

The following pic shows the extra replacements requested that do not show up in the replacement troops window. I had 8 units of 8 ready and they delivered, what are the 29 others?

[image]local://upfiles/75928/744CEFDD72454F03B4F1C37D6DA2CB36.jpg[/image]



zgrssd -> RE: Mysterious Replacements Requested (7/20/2021 8:41:14 AM)


quote:

ORIGINAL: arvcran2

Every turn I see reports on failed replacement troops - is this Militia units?

The following pic shows the extra replacements requested that do not show up in the replacement troops window. I had 8 units of 8 ready and they delivered, what are the 29 others?

[image]local://upfiles/75928/744CEFDD72454F03B4F1C37D6DA2CB36.jpg[/image]

There are two options:
1. Those are indeed militia
2. The supply line somewhere along the line to the actuall unit is taxed out.

You do have some problems with SHQ > Unit supply, so I would guess 2 is at least a factor.



arvcran2 -> RE: Mysterious Replacements Requested (7/20/2021 11:34:37 AM)

How can I tell what militia replacements are needed, and how do I promote them to be replaced?

I am pretty sure it is not my units that are unable to be replaced as all of them were delivered from the SHQ.

The unit quality replacement paradigm as far as I know was not active since I did not alter my unit's quality settings, though the models were set to low, and regular.



zgrssd -> RE: Mysterious Replacements Requested (7/20/2021 4:20:21 PM)

You could check milita repalcements by going over the militia units.

There is no way for your to create them. They are automatically created. But more often nothing is created at all, becuase the Militia is already too large. I usually disband undermanned militia units. The subunits can then be used by other militia units in the field.

Setting models to low and regular is one half of the automatic replacement. The 2nd - more important part - is telling the units to only tollerate low, but allow regular.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
1.191406