Transport TF Management (Full Version)

All Forums >> [Current Games From Matrix.] >> [World War II] >> War In The Pacific - Struggle Against Japan 1941 - 1945



Message

newbie101 -> Transport TF Management (12/16/2004 9:51:22 PM)

I am confused. I created a number of transport TF's in several base hexes with instructions to load supplies. I then indicated a destination hex for another base hex. I had read, I believe in the manual and in this forum, it was important to do this in that, otherwise, the TF would repeatedly load and unload but never get out of port. The next turn, when reviewing the status of my TF's I notice that several transport TF's had left port but with only partially filled holds. Did I do something wrong and, if so, what?

I appreciate your help. Thanks in advance.



Mr.Frag -> RE: Transport TF Management (12/16/2004 9:53:37 PM)

A ship will never take more then 90% of whats available in the port. If there was not enough, they will finish loading and immediately leave.



pasternakski -> RE: Transport TF Management (12/16/2004 10:22:38 PM)

If what Frag mentions is not the problem, try setting the destination first, then giving the load order.



Mr.Frag -> RE: Transport TF Management (12/16/2004 10:24:54 PM)

Should not matter anymore ... the only case a location is needed prior to clicking load is with fast transport TF's since they control how much they load based on their destination to make sure they don't get stuck there during daylight by being overloaded.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
1.515625