scenario editor "support percentage %" requirements NOT displaying

Matrix Games Forums

Forums Register Login Photo Gallery Member List Search Calendars FAQ

My Profile Inbox Address Book My Subscription My Forums Log Out

scenario editor "support percentage %" requirements NOT displaying

View related threads: (in this forum | in all forums)

Logged in as: Guest

Users viewing this topic: none

Printable Version

All Forums >> [New Releases from Matrix Games] >> Gary Grigsby's War in the East 2 >> Scenario Design and Modding >> scenario editor "support percentage %" requirements NOT displaying

Page: [1]

Message

<< Older Topic Newer Topic >>

scenario editor "support percentage %" requir... - 4/18/2021 12:48:14 AM

oldMarinePanzer

Posts: 82
Joined: 2/9/2015
Status: offline

I'm in the scenario editor and I am creating a new unit. I populated it and set added 600 support units because it is a division, but even though I have added 12-15 ground elements. Usually the game engine analyzes these elements and comes up with a "support percentage %" requirements. The number necessary to support all the ground elements in this division. Is there a way to make the game engine generate this? The only number displayed is zero.

Post #: 1

RE: scenario editor "support percentage %" re... - 4/18/2021 3:49:02 AM

jlbhung

Posts: 280
Joined: 3/10/2021
Status: offline

I faced the same problem initially as this was different from WitE1's Editor. Later I found that in the Main Tab, there was a "RESET UNIT SUPPORT VALUES" in the list of functions on the right hand side.

(in reply to oldMarinePanzer)

Post #: 2

RE: scenario editor "support percentage %" re... - 4/18/2021 1:31:10 PM

oldMarinePanzer

Posts: 82
Joined: 2/9/2015
Status: offline

jlbhung - thanks, I looked there too, hiding in plain sight - thanks again

(in reply to jlbhung)

Post #: 3

Page: [1]

All Forums >> [New Releases from Matrix Games] >> Gary Grigsby's War in the East 2 >> Scenario Design and Modding >> scenario editor "support percentage %" requirements NOT displaying

Page: [1]