scenario editor "support percentage %" requirements NOT displaying (Full Version)

All Forums >> [New Releases from Matrix Games] >> Gary Grigsby's War in the East 2 >> Scenario Design and Modding

Message

---

oldMarinePanzer -> scenario editor "support percentage %" requirements NOT displaying (4/18/2021 12:48:14 AM) I'm in the scenario editor and I am creating a new unit. I populated it and set added 600 support units because it is a division, but even though I have added 12-15 ground elements. Usually the game engine analyzes these elements and comes up with a "support percentage %" requirements. The number necessary to support all the ground elements in this division. Is there a way to make the game engine generate this? The only number displayed is zero.

---

jlbhung -> RE: scenario editor "support percentage %" requirements NOT displaying (4/18/2021 3:49:02 AM) I faced the same problem initially as this was different from WitE1's Editor. Later I found that in the Main Tab, there was a "RESET UNIT SUPPORT VALUES" in the list of functions on the right hand side.

---

oldMarinePanzer -> RE: scenario editor "support percentage %" requirements NOT displaying (4/18/2021 1:31:10 PM) jlbhung - thanks, I looked there too, hiding in plain sight - thanks again

---

Page: [1]

Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI

2.15625