|
boggyjr -> RE: How to add command points? (2/8/2007 3:07:02 AM)
|
quote:
ORIGINAL: nmleague
For the QB to throw the ball, at his last command point give him "pass" logic.
For the receiver to catch the ball, or for the QB to throw to a receiver the receiver must have "look for pass" logic. For example if a R is doing a down and out pattern, say moves to his first command point downfield about 6 yards, at that command point give him to logic command, first, look for pass, second, move to next point. Put his next command point out by the sidelines.
QB will not throw the ball to any player that is not looking for the ball, watch your timing, if the QB is in a shotgun formation and his only logic command is "pass to", he will not pass until a receiver reachs a command point at which he has a look for pass logic. So if all R are runnig deep routes and dont look for a pass until late the QB will probably have been triggered to scramble if he waited to long.
Hope this helps.
Yep, I understood how that worked....but....
Nothing ever shows up in those boxes where you select what the player does at the command points. I try and click on a player in the "After Snap" editing mode, and it gives me a "Press F9 to continue" screen. Then, three command point boxes show up, but when you click on them, nothing is in them. I can't even tell my QB to do anything. No options to select from.
|
|
|
|
