Area defined by RPs visible for both sides (Full Version)

All Forums >> [New Releases from Matrix Games] >> Command: Modern Operations series >> Mods and Scenarios



Message

invernomuto -> Area defined by RPs visible for both sides (10/14/2013 9:30:39 PM)

In the editor I added my sides, Blue and Red. I defined an "ASW Area" with four RPs with the "add area" tool for Blue side. If I switch to the Red side, the RPs disappear.
Can I define reference points that are visible for both sides?
Thanks in advance!



Primarchx -> RE: Area defined by RPs visible for both sides (10/14/2013 9:31:54 PM)

No, that doesn't work (and for good reason).

In these cases I will place Neutral Units on the RP locations, then switch to the other side and place RPs on the Neutral Units.



invernomuto -> RE: Area defined by RPs visible for both sides (10/15/2013 10:29:29 AM)

I tried yesterday but i cannot move neutral unit on a RP:
I select the neutral unit, press "M" and click on the RP. Unit does not move and RP get selected. How can I "force move" the unit on it?

Thanks in advance,
bye.



Meroka37 -> RE: Area defined by RPs visible for both sides (10/15/2013 6:23:11 PM)

One way is:

- Select the unit
- Press M
- Zoom max (with Z and mouse on top RP)
- Click close to the RP , but not "on" the RP



Primarchx -> RE: Area defined by RPs visible for both sides (10/15/2013 8:26:45 PM)

This

quote:

ORIGINAL: Meroka37

One way is:

- Select the unit
- Press M
- Zoom max (with Z and mouse on top RP)
- Click close to the RP , but not "on" the RP




Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
2.5625