Shannon V. OKeets -> RE: Simple question re: supply (11/18/2013 7:19:43 PM)
|
quote:
ORIGINAL: Deerslayer quote:
ORIGINAL: Shannon V. OKeets quote:
ORIGINAL: gap23518 I knew that rule about hex distances but didn't know about only Warsaw being a supply source after Poland was conquered. I thought the other two cities would be supply points but I found the rule which states its not the case. This is one of those cases where the proper rule was not located! thanks Try F8. That will bring up the Supply Sources and Paths form. You can check out Germany's primary and secondary (maybe some tertiary) supply sources. I've spent some time with this form/tutorial. Is there anyway to check the path from an actual front line unit directly versus just a HQ or city source? Seems you only get a "path" when clicking on a HQ or some type of supply source versus actual front line unit. Can't figure it out anyway. - If you place the cursor over a unit, its supply source is shown in the bottom line of the Unit Data panel (e.g., the one in the Main form). - Then use F8 to bring up the Supply form and find the supply source listed for the unit's major power. - The unit should appear in the list at the bottom of supplied units by the supply source. - Click on the unit in that list and the path from the unit to the supply source will appear in the Path portion of the form. - Click on an entry in the path, and the insert map will center on the hex/sea area.
|
|
|
|