Torpedo targeting (Full Version)

All Forums >> [New Releases from Matrix Games] >> Command: Modern Operations series



Message


beads -> Torpedo targeting (8/24/2021 2:30:33 PM)

Trying to work out torpedo use.

In Harpoon I wwould set an activation point at which the torpedo would go active and start homing in on the target, usually from a different bearing to the one I was on.

When I do a BOL launch in CMO I'm not sure if this sets an activation point, as the sensor arc shows immediately, and I finally worked out that after a BOL you have to use f1 on the target to get the torpedo to actually try to home in on it.

Am I doing something wrong here? Rather than selecting a target, I would expect the active sonar to guide the torpedo to whatever it detects.

Is there a better way to get a torpedo to go active to home in on a target from a direction that _doesnt_ show them exactly where I am?

Thanks




DWReese -> RE: Torpedo targeting (8/24/2021 3:53:59 PM)

I'm doing this from memory, so if I am saying something that is incorrect, then someone will correct me, of that I'm sure. I'm answering you because no one else is, so take my information for what it's worth.

Unless they are wire-guided, ALL torpedoes are essentially BOL. Yes, you can send them in a direction, and there may be a way to activate them further down their intended path, but I don't know how to do it (sub warfare is not my specialty).

Most wire-guided torpedoes in the game will remain "guided unless the firing sub exceeds 10 kts. At that point, the wire breaks and the torpedo immediately goes active. Using that logic, it would seem that the game is likely set up in a similar manner. If it's not guided, then it will start searching pretty soon after it is fired. Obviously, you can set the path for the BOL, and the sub will try to follow that path unless it finds a target, but the torpedo is sort of on its own once fired.

In answer to your question, I don't know how to set BOL and then activate later, nor do I know if it can even be done.

Hopefully this will help. If not, then hopefully someone with more sub knowledge will come along and answer your question properly for you.




beads -> RE: Torpedo targeting (8/24/2021 6:46:11 PM)

Thanks for the reply!

I hope there is a way to control activation as it was a key part of my submarine game - if you can activate a torpedo so that it closes on the Target from an entirely different bearing to the one you are on you have a much better chance of staying hidden.

I will do some more experimenting.




Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
3.375